image1.jpg
I'm using an MGW Sight-Pro in an attempt to drift the rear sight slightly to the left on a .45 ACP Colt 1911 Night Defender...without any bloody success at all. Frustrated.
I removed the retaining screw...added a little lubricant under the sight (with a prayer)...everything on the MGW is nice & tight...I've hand cranked the sight pusher gears more than you know without moving anything & I'm afraid to apply more pressure...I'm leaving the slide as it is in the MGW over night...tomorrow I'll check the Board to see if anyone posted any pearls of wisdom before I touch it again.
Anyone know why Colt would "weld" the rear sight to the Defender's slide?
Bookmarks