I recieved my new loadmaster this weekend. Setup was very basic just setting dies and verifying powder drop. This press came with the pro auto disk powder measure. InitiaIly the powder drop is inconsistant so i put my auto drum on the press. The auto drum is turning out to be very consistent. I suspect i may need to work the auto disk a bit to get the graphite from the powder to get worked in. I believe thats what i read. Getting the thing mounted was the most difficult part. I did the same as my single stage. I mounted it on a 2 x 8. This i cut 22 inches long and mounted it with a 1/4 inch bolt thru the bench. This bolt is about 16 inches from the front of the board. I did also notch the front of the board to set the press back 3/4 inch. 5/16 bolts fasten the press to the board. The whole setup is very stable. Though i do need to recess the washer and head of the bolts later. I did realize very quickly there is a lot to watch while operating the press. 80 rds and off to the range to test. I need more brass
Bookmarks