reloading dies for dummy rounds
I need to assemble a small number (just a couple dozen) of dummy 45 ACP rounds for feed function testing. I have no reloading equipment at all, but I can set up some type of press just for this purpose.
These will only consist of new FMJ 230 gr bullets and brass. No powder or primer.
I am trying duplicate factory ammo dimensions, so I believe I will need a taper crimp die of some type?
Do I need to flare or chamfer the case mouths?
I'm pretty sure I can fashion a seating die of some type out of Delrin or something and get the bullets seated.
-