Welcome to M1911.ORG
The M1911 Pistols Organization Forums Site


John needs your help
Please read this message.


Sponsors Panel
If you intend to buy something from the companies advertising above, or near the bottom of our pages, please use their banners in our sites. Whatever you buy from them, using those banners, gives us a small commission, which helps us keep these sites alive. You still pay the normal price, our commission comes from their profit, so you have nothing to lose, while we have something to gain. Your help is appreciated.
If you want to become a sponsor and see your banner in the above panel, click here to contact us.

  • Section Widget

  • Categories Widget (Show All)

  • Recent Articles

  • Recent Forum Posts

    Hawkmoon

    Hello

    That's how I always do it -- using a 1/8" punch from the back side to align the holes in the mainspring housing with the holes in the frame.

    Hawkmoon 16th May 2024, 07:31 Go to last post
    Doran

    Hello

    Good you could finally get it reassembled. Sometimes tolerance stack up, burrs or etc can cause problems.

    Doran 16th May 2024, 01:27 Go to last post
    SkvyWvr

    Hello

    Well finally got the installed after lining up with a punch from the opposite side. Much thanks to everyone for all the help. Now onto the new thumb safety.

    SkvyWvr 15th May 2024, 10:13 Go to last post



Sponsors Panel
If you intend to buy something from Brownells, please use their banners above. Whatever you buy from them, gives us a small commission, which helps us keep these sites alive. You still pay the normal price, our commission comes from their profit, so you have nothing to lose, while we have something to gain. Your help is appreciated.
If you want to become a sponsor and see your banner in the above panel, click here to contact us.

Non-gun-related supporters.
Thank you for visiting our supporters.