anyone used C&S trigger pull sets?

[StrykerDM]

Cylinder and Slide trigger pull set (http://www.brownells.com/aspx/ns/store/ProductDetail.aspx?p=5502&title=1911%20AUTO%20TRIGGER%20PULL%20KITS)

anybody use these? Are they difficult to fit for somebody who hasn't done gunsmithing work before? I was looking into cheaper ways to improve my RIA compact 1911's trigger and ran across these sets online. Any advice?

[niemi24s]

While I haven't used them myself, they've been discussed several time on this Forum with, IIRC, favorable comments. Maybe using our search engine will turn up the info you're looking for.

Cheers

[StrykerDM]

While I haven't used them myself, they've been discussed several time on this Forum with, IIRC, favorable comments. Maybe using our search engine will turn up the info you're looking for.

Cheers

you're right! looks good to go...time to hint to the fiancee that it'd make a nice Christmas present

[Ben H]

I've used several with great results. Most have dropped straight in without any creep and the ones that did creep a little were easy to correct. Back in the 90's a crack developed on the hammer on my PPC 9mm and C&S replaced it with no questions asked.

Ben H

[niemi24s]

...time to hint to the fiancee that it'd make a nice Christmas present No, no, no . . . you're going about it all wrong!

Just get your new gizmo and give it to her saying something like "I know you're real busy during the holidays, so I thought I'd help out by getting this gizmo - to save you the worry & bother over what to get me." ;)

Works for me!

Cheers

[StrykerDM]

one more question about the C&S sets...it should fit on my 1911 officers model correct? or are the mainsprings and sear springs dependent on which model 1911 you have? sry for the newb questions...