.575x40 Compensator thread tap

[kcb_1983]

Hi,
I would like to know if someone makes a .575"x40 tpi thread tap. I need one to clean up a comp before I install it.

regards,

[niemi24s]

Without even looking in the catalogs, have a hunch if anybody did make them, they were made specially for the manufacturer of the compensator. And if the compensator threads were cut other than by tapping, there may be no such tap.

But, if anybody does have one it would probably be Brownells. Lots of luck! Cheers

[log man]

kcb_1983,Brownell's carries both tap and die in .575-40, part no. for tap is #080-598-575 page 45 in catalog #60. :D