10-8 Performance Sight -- SWEET!!!

[sethmark]

I just received and installed the 10-8 Performance rear on my TRP with a Dawson F/O front. WAY sweet sight picture and PERFECT fit for both. The rear required just a whisker of filing (better than being undersized!!!!) and fit with zero gaps. Customer service was amazing. Ordered it Christmas eve and it arrive 2 days later.

http://www.offroadmarketing.com/10-8-1.jpg

http://www.offroadmarketing.com/10-8-2.jpg

[Quasi Moto]

Nice looking set up. May try it for my IPDA/USPSA gun.

[sethmark]

That's what I did it for. Single Stack in USPSA and CDP in IDPA.

[jhp147]

Sethmark, I just put one of these on my TRP. Weather has prevented me from testing it. Have you checked the zero with factory spec ball, and if so, what height front sight do you have? TIA!

[sethmark]

Sethmark, I just put one of these on my TRP. Weather has prevented me from testing it. Have you checked the zero with factory spec ball, and if so, what height front sight do you have? TIA!
I used factory replacement height sights. The rear is a .375" and the front .180". That's exactly what came off of the gun. I haven't shot it yet, as the rear went on yesterday morning, but I sighted them with a bore laser and the POI is the same. I rare shoot ball, so that's not much of a concern.

Seth

[jhp147]

Thanks, mine had to be changed by the factory to hit with the original factory sights, shooting low (normal for SA, I gather). I just changed out front and rears, back to the 2nd factory sight, and I hope I'm on. I think my sight is .180 now, but I'll have to recheck it.

[sethmark]

Springfield uses a taller sight package on the TRP, apparently. I was not aware of that before I started this process.

The typical rear is .325". The TRP uses a rear that .05" over that. It also employs a 6 o'clock hold, which is definitely my preference. All in all, I'm QUITE happy with my sight picture now. They're way easy to track when they lift.