PDA

View Full Version : 38 Super to .22LR Conversion

sailou
17th September 2007, 13:22
New here, I searched but could not find anything on a 38 Super to .22LR conversion. Would a Marvel Unit 1 work for a Para Ordnance 38 Super? And if not, are there any conversion kits that would?

Thanks,

Lou
John
17th September 2007, 13:33
Normally, it should work fine. Especially on a Para Ordnance, which has not ramp on the frame.
sailou
18th September 2007, 16:28
Thanks John!
robot1911
18th September 2007, 19:55
I've never tried to match these two and I can see no problem areas other than maybe the ejector. The Super ejector may interfere with the location of the Marvel's.

Bob
Joni Lynn
18th September 2007, 20:06
The ejector should be the only problem. It may not fit the slide.
TonyT
14th October 2007, 10:49
Don't know if it would fit the Po 38 Super. Neither of my two Marvel units nor the Jarvis unit would fit on my PO 18-9LDA Limited or the SA 9mm Target.
New here, I searched but could not find anything on a 38 Super to .22LR conversion. Would a Marvel Unit 1 work for a Para Ordnance 38 Super? And if not, are there any conversion kits that would?

Thanks,

Lou
robot1911
14th October 2007, 12:47
The ejectors on the 9mm and 38 Super are further inboard than the .45ACP. Their slides are milled to accommodate this but the .22 conversions are not.

Bob