What Extended Mag Well fits SA & works w/CMc 10 round mags

[wheelgunner]

I recently installed an Ed Brown Drop-in Flat Snakeskin Blue Mainspring Housing Maxi-Well. Fit is fair on my Mil-Spec there is a gap at front because the housing sits up higher in the frame and is not flush with the frame. I could live with it but I use 10 round Chip McCormick 10 round power mags and they will not fit.

http://i203.photobucket.com/albums/aa2/wheelgunner_photos/DSC00708.jpg

Does anyone know which Drop-in Extended Magazine Well will allow Chip McCormick 10 round magazines to seat in the gun? :confused:

Thanks.

Dan

[Al45]

I have Brown, Wilson, and S&A magwell/MSH on different 1911 units, and I had to take the Dremel to the top of the CMC 10’s base to get them to fit. It’s just a matter of taking a little off so that the upper part of the base follows the angle of the magwell. After the first one, the other were fast. You won’t have a problem with any other 10 rounders, it’s just because of the base on the CMC.