Ambi Safety

[flyhalf]

Is there a guide any where on the website regarding the installation of an ambi safety????
Thanks in advance.
1LT Infidel

[John]

Nope, but the ambis are not different than the single-side ones. First make sure that you fit the left side of the safety properly in your pistol (and by properly I mean you should fit it so that it completely blocks the sear movement, but allow full movement when released) and them just insert the right part.

Since there are several ways that the right part is held in place, I can't give you more instructions, until I know how the right part is kept there, in your particular safety.

One hint. In order to see what's going on inside the pistol, when fitting the left part of the safety, have your pistol assembled, minus the grip safety. Everything else in place but no grip safety. That would allow you to see the internals.

[flyhalf]

Shite, I might just go to a gun smith for it then. And, while I am there, have him install either a new hammer and new trigger. $$$ depending.
It's a 1991 and I wanted to 1. make it lefty friendly and 2. make it a little "better"
Thanks for the info though

Lead the Way