- Function of the Disconnector
- Recoil Function
- Magazine Function: The Dimple
- Recoil Spring Function
- STI's "How the 1911 works" animation
- A quick analysis of the various Loctites
- Recoil Operation of the 1911
- Barrel Drop Clearance
- Clinic-3: BFC
- Headspace
- Controlled Feed Principles
- The hammer follows to half-cock when I release the slide. Is that a problem?
- Why is it bad to drop the slide without a loaded magazine?
- Why you SHOULD NOT use a dremel when polishing your ramp
- Amazing reduction in perceived recoil with a simple part change - EGW firing pin stop
- DIY Sights Installation
- How to test the thumb safety of a 1911
- Ejection diagnosis help!
- 1911 Clinic
- My hammer follows, what's the problem?
- Recoil
- Colt Parts, MIM? Forged? Cast?
- Lowering Frame Bed
- Link Fitting - Voice of Experience Needed
- Stopping Barrel Fall At Linkdown
- Fitting a new barrel
- Malfunction Clinic
- 1911 Inspection Checklist
- MainSpring Housing swap and getting rid of the ILS - How to
- How taller (or shorter) front sight I need? My gun shoots high/low
- Fitting a thumb safety, steps involved
- How to test if your recoil spring is binding
- Why are short 1911s considered to be unreliable?
- 1911 Firing Sequence (or when does the slide move?)
- Front sight cuts dimensions
- Staking that pesky front sight
- Wilson Combat Grip Safety Radius Specs
- "1911" thumb safety in operation
- Trigger job question
- Tripp Research Videos
- Slide not aligned with the rear of the frame. What do I do?
- LJA's Evidence Thread: Explanation
- Frame nomenclature
- Sear modification to prevent interference with the disconnector
- 1911 gunsmithing tools
- Series 70 drop tests
- How to stake the Barrel Link Pin
- Browning 1911 patent document
- Firing out of battery myth
- What we need to know, to help troubleshooting a 1911
- Which beavertail for RIA 1911a1 FS and how to fit a beavertail
- When does the slide start moving?
- 1911 Ejectors